Monorail Connectors

To install a MonoRail system to a T-bar drop ceiling, add a T-bar connector to every standoff (sold separately).The T-bar clip twists into the slat. (Use only if local electrical codes allow). Specify 15/16" or 9/16" slat.

Adapts any FreeJack head or pendant to Tech Lighting’s MonoRail system.

To install a MonoRail system to a T-bar drop ceiling, add a T-bar connector to every standoff (sold separately).The T-bar clip twists into the slat. (Use only if local electrical codes allow). Specify 15/16" or 9/16" slat.

To install a MonoRail system to a T-bar drop ceiling, add a T-bar connector to every standoff (sold separately).The T-bar clip twists into the slat. (Use only if local electrical codes allow). Specify 15/16" or 9/16" slat.

The "T" connector joins three pieces of MonoRail to form a "T".These connectors are conductive, so you may power the system from any of the runs. At least one standoff must be located near the connector.

Adapts any FreeJack head or pendant to Tech Lighting’s MonoRail system.

The "T" connector joins three pieces of MonoRail to form a "T".These connectors are conductive, so you may power the system from any of the runs. At least one standoff must be located near the connector.

Isolating connectors join sections of rail and isolate power feeds from each other.Two common uses are in runs using more than 300w or in runs over 30ft where two power feeds are required to avoid voltage drop. All dual-feed canopies and dual-feed...

The "X" connector joins four pieces of MonoRail to form an "X".These connectors are conductive, so you may power the system from any of the runs. At least one standoff must be located near the connector.

Conductive connectors join sections of rail together end to end and are included with all MonoRail pieces.Order separately if cutting and rejoining rails. Pair.

These conductive connectors join sections of rail together end to end at desired vertical angle.Pair.

These conductive connectors join sections of rail together end to end at desired vertical angle.Pair.

These conductive connectors join sections of rail together end to end at desired sharp horizontal angle.Pair.

To install a MonoRail system to a T-bar drop ceiling, add a T-bar connector to every standoff (sold separately).The T-bar clip twists into the slat. (Use only if local electrical codes allow). Specify 15/16" or 9/16" slat.